User's Manual
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Accessories
- Chapter 5. Secure your computer and information
- Chapter 6. Configure advanced settings
- Chapter 7. CRU replacement
- Chapter 8. Help and support
- Appendix A. Important safety information
- Appendix B. Accessibility and ergonomic information
- Appendix C. Supplemental information about the Linux operating system
- Appendix D. Compliance and TCO Certified information
- Appendix E. Notices and trademarks
4. Remove the screw that secures the M.2 solid-state drive bracket 1 and remove the M.2 solid-state drive
bracket
2 . Then, remove the M.2 solid-state drive out of the drive slot 3 .
5. Install the new M.2 solid-state drive on the bracket 1 and insert the new M.2 solid-state drive with the
bracket to the drive slot
2 . Then, install the screw to secure the bracket 3 .
6. Reinstall the base cover assembly and the nano-SIM-card tray.
7. Connect the ac power adapter and all disconnected cables to the computer.
Coin-cell battery
Prerequisite
Before you start, read Appendix A “Important safety information” on page 83 and print the following
instructions.
Replacement procedure
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 53.
2. Turn off the computer and disconnect the computer from ac power and all connected cables. Then,
close the computer display
62
T14 Gen 1, T15 Gen 1, P14s Gen 1, and P15s Gen 1 User Guide