User Manual

Removal steps of the power button board cable
Ensure that you remove the thermal fan before removing the power button board cable.
Step Screw (quantity) Color
Torque
2
M2 × L2.2 mm, flat-head, nylon-coated (1)
Black 0.181 Nm
(1.85 kgf-cm)
1060 Built-in battery
Important notices for replacing a battery
Attention: Lenovo has no responsibility for the performance or safety of unauthorized batteries, and
provides no warranties for failures or damage arising out of their use.
The Lenovo Solution Center program provides an automatic battery diagnostic test that determines if the
battery is defective. A battery FRU should not be replaced unless this diagnostic test shows that the battery
is defective. The only exception to this is if the battery is physically damaged or a customer is reporting a
possible safety issue.
If the Lenovo Solution Center program is not installed on the computer, the customer should download and
install the program to diagnose the battery, before getting a non-physically damaged battery replaced. Note
that the replacement of a physically damaged battery is not covered by the warranty.
For access, remove this FRU:
• “1010 Base cover assembly” on page 59
64
ThinkPad X1 Nano Gen 2 Hardware Maintenance Manual