User Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. Important service information
- Chapter 3. General checkout
- Chapter 4. Related service information
- Chapter 5. Special keys
- Chapter 6. Locations
- Chapter 7. FRU replacement notices
- Chapter 8. Removing or replacing a FRU
- General guidelines
- Before servicing the computer
- 1010 Base cover assembly
- 1020 2242 M.2 solid-state drive
- 1030 Wireless-WAN card (for selected models)
- 1040 Thermal fan assembly
- 1050 Power button board and power button board cable
- 1060 Built-in battery
- 1070 Speaker assembly near the built-in battery
- 1080 Trackpad, fingerprint reader and P-sensor cable
- 1090 Trackpad
- 1100 Fingerprint reader module and bracket
- 1110 Wireless-LAN antenna assembly
- 1120 System board assembly
- 1130 Wireless-WAN antenna assembly (for selected models)
- 1140 Speaker assembly near the hinges
- 1150 LCD unit
- 1160 Keyboard bezel assembly with keyboard
- Appendix A. Notices
- Appendix B. Abbreviation table
Attention: When you route the cables, ensure that they are not subject to any tension. Tension could cause
the cables to be damaged by the cable guides, or a wire to be broken.
When installing: ensure that you connect the orange cable to the main connector, and the blue cable to the
auxiliary connector.
Antenna locations
a Wireless WAN antenna (MIMO 2)*
b Wireless WAN antenna (MIMO 1)*
c Wireless WAN antenna (auxiliary)*
d Wireless WAN antenna (main)*
* for selected models
1140 Speaker assembly near the hinges
For access, remove these FRUs:
• “1010 Base cover assembly” on page 59
80
ThinkPad X1 Nano Gen 2 Hardware Maintenance Manual