User's Manual
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Secure your computer and information
- Chapter 5. UEFI BIOS
- What is UEFI BIOS
- Enter the BIOS menu
- Navigate in the BIOS interface
- Change the display language of UEFI BIOS
- Change the display mode of UEFI BIOS
- Set the system date and time
- Change the startup sequence
- Enable or disable the configuration change detection feature
- Enable or disable the automatic power-on feature
- Enable or disable the smart power-on feature
- Enable or disable the ErP LPS compliance mode
- Change the ITS performance mode
- Change BIOS settings before installing a new operating system
- Update UEFI BIOS
- Recover from a BIOS update failure
- Clear CMOS
- Chapter 6. RAID
- Chapter 7. Troubleshooting, diagnostics, and recovery
- Chapter 8. CRU replacement
- What are CRUs
- Replace a CRU
- ac power adapter and power cord
- Rear Wi-Fi antenna
- Vertical stand
- VESA mount bracket
- External optical drive box and external optical drive
- Power adapter bracket
- Dust shield
- Computer cover
- Internal speaker
- System fan
- Coin-cell battery
- PCIe card and PCIe converter
- Wi-Fi card and Wi-Fi card shield
- Bottom cover
- M.2 solid-state drive
- Memory module
- Chapter 9. Help and support
- Appendix A. System memory speed
- Appendix B. Important safety information
- Appendix C. Accessibility and ergonomic information
- Appendix D. Supplemental information about the Ubuntu operating system
- Appendix E. Compliance and TCO Certified information
- Appendix F. Notices and trademarks
5. Always On USB 3.2 connector
Gen 2
With the Always On USB feature enabled, the Always On USB 3.2 connector Gen
2 can charge a USB-compatible device when the computer is on, off, in sleep
mode, or in hibernation mode.
To enable the Always On USB feature, do the following:
1. Enter the UEFI BIOS menu. See “Enter the BIOS menu” on page 21.
2. Click Devices ➙ USB Setup ➙ Front USB Ports ➙ USB Port 2 to enable
the Always On USB feature.
6. Headset connector
Connect a headset or headphones to your computer.
2 P340 Tiny User Guide