User Manual

Chapter 2. 2-7
Selecting a supported display mode
The display mode the monitor uses is controlled by the computer. Therefore, refer to your
computer documentation for details on how to change display modes.
The image size, position and shape might change when the display mode changes. This is
normal and the image can be readjusted using automatic image setup and the image controls.
Unlike CRT monitors, which require a high refresh rate to minimize icker, LCD or Flat Panel
technology is inherently icker-free.
Note: If your system has previously been used with a CRT monitor and is currently congured
to a display mode outside the range of this monitor, you may need to reattach the CRT monitor
temporarily until you have re-congured the system; preferably to 3840 x 2160 at 60 Hz, which
is the Native Resolution Display mode.
The display modes shown below have been optimized at the factory.
Table 2-3. Factory set display modes
Timing Refresh rate(Hz)
640x480 60 Hz
720x400 70 Hz
800x600 60 Hz
1024x768 60 Hz
1280x720 60 Hz
1280x800 60 Hz
1280x1024 60 Hz
1440x900 60 Hz
1600x900 60 Hz
1680x1050 60 Hz
1920x1080 60 Hz
1920x1200 60 Hz
2560x1440 60 Hz
3840x2160 30 Hz
3840x2160 60 Hz