User Manual

1-6 P24q-30 Flat Panel Monitor User’s Guide
4. Connect one end of the USB 3.0 cable to the USB connector on the back of the computer, and the
other end to the upstream USB connector on the monitor.
5. Connect the speaker’s audio cable and audio jack of monitor to transfer audio source from DP,
HDMI.
Note 1: The audio output in DP and HDMI modes.
Note 2: Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
6. Connect one end of the USB cable to the USB downstream terminal of the monitor, and connect the
other end of the USB cable to an appropriate USB port on your device.
Note 1: The USB downstream port does not provide power while the monitor is switched off. (To use
top port USB, first remove the rubber cover）
Note 2: Power output for USB-A: 5V/0.9A, USB-BC1.2: 5V/2.4A. (To use top port USB, first remove
the rubber cover)
If there are any * tag, you can consult the comments on page 1-1.