Owner's Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. General checkout
- Chapter 3. Identifying FRUs (CRUs)
- Chapter 4. Removing a FRU or CRU
- Service tools
- General guidelines
- Removal procedure for IdeaPad Flex 5 14IAU7 and IdeaPad Flex 5 14ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD)
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the system board
- Remove the touchpad
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Removal procedure for IdeaPad Flex 5 16IAU7 and IdeaPad Flex 5 16ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD) module
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the touchpad
- Remove the system board
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Appendix A. Label locations
- Trademarks
Figure 22. Remove the speakers
Go to https://support.lenovo.com/partslookup to look up the Lenovo part number of the following replacement
part:
Speakers
Remove the antenna
Make sure the following FRU (CRU) has been removed.
“Remove the lower case” on page 35
“Remove the battery pack” on page 36
Step 1. Peel off the piece of tape then detach the main and auxiliary antenna cable connectors.
Figure 23. Detach the main and auxiliary antenna cable connectors
Step 2. Release the antenna from the cable guide. Remove the antenna.
Chapter 4. Removing a FRU or CRU 45