Owner's Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. General checkout
- Chapter 3. Identifying FRUs (CRUs)
- Chapter 4. Removing a FRU or CRU
- Service tools
- General guidelines
- Removal procedure for IdeaPad Flex 5 14IAU7 and IdeaPad Flex 5 14ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD)
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the system board
- Remove the touchpad
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Removal procedure for IdeaPad Flex 5 16IAU7 and IdeaPad Flex 5 16ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD) module
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the touchpad
- Remove the system board
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Appendix A. Label locations
- Trademarks
Step 2. Disconnect the fingerprint board cable from the fingerprint board and system board. Remove the
fingerprint board cable.
Figure 64. Remove the fingerprint board cable
Step 3. Remove fingerprint board.
Figure 65. Remove fingerprint board
Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following
replacement parts:
Fingerprint board bracket
Fingerprint board cable
Fingerprint board
Remove the speakers
Make sure the following FRU (CRU) has been removed.
“Remove the lower case” on page 60
“Remove the fan” on page 65
“Remove the heat sink” on page 65
Chapter 4. Removing a FRU or CRU 69