Owner's Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. General checkout
- Chapter 3. Identifying FRUs (CRUs)
- Chapter 4. Removing a FRU or CRU
- Service tools
- General guidelines
- Removal procedure for IdeaPad Flex 5 14IAU7 and IdeaPad Flex 5 14ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD)
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the system board
- Remove the touchpad
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Removal procedure for IdeaPad Flex 5 16IAU7 and IdeaPad Flex 5 16ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD) module
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the touchpad
- Remove the system board
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Appendix A. Label locations
- Trademarks
Figure 70. Remove touchpad cable
Go to https://support.lenovo.com/partslookup to look up the Lenovo part number of the following replacement
part:
Touchpad cable
Remove the touchpad
Make sure the following FRUs (CRUs) have been removed.
“Remove the lower case” on page 60
“Remove the battery pack” on page 61
“Remove the solid-state drive (SSD) module” on page 62
“Remove the Wi-Fi card” on page 64
“Remove the heat sink” on page 65
“Remove the fan” on page 65
“Remove the touchpad cable” on page 71
“Remove the system board” on page 73
Step 1. Remove the fingerprint board cable.
Note: For details, see “Remove the fingerprint board module” on page 68.
Step 2. Remove the two pieces of tape.
Figure 71. Remove the two pieces of tape
72 Hardware Maintenance Manual