Owner's Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. General checkout
- Chapter 3. Identifying FRUs (CRUs)
- Chapter 4. Removing a FRU or CRU
- Service tools
- General guidelines
- Removal procedure for IdeaPad Flex 5 14IAU7 and IdeaPad Flex 5 14ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD)
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the system board
- Remove the touchpad
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Removal procedure for IdeaPad Flex 5 16IAU7 and IdeaPad Flex 5 16ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD) module
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the touchpad
- Remove the system board
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Appendix A. Label locations
- Trademarks
Figure 84. Remove the LCD panel
Step 4. Turn the LCD panel over. Peel off tape then disconnect the EDP cable from the LCD panel.
Figure 85. Peel off tape then disconnect the EDP cable from the LCD panel
Go to https://support.lenovo.com/partslookup to look up the Lenovo part numbers of the following
replacement parts:
LCD panel
Removable tape
EDP cable
Remove the microphone rubbers
Make sure the following FRUs (CRUs) have been removed.
“Disassemble the LCD unit” on page 78
“Remove the hinge cover” on page 78
“Remove the LCD panel and EDP cable” on page 78
Step 1. Remove the microphone rubbers.
80
Hardware Maintenance Manual