Owner's Manual
Table Of Contents
- About this manual
- Chapter 1. Safety information
- Chapter 2. General checkout
- Chapter 3. Identifying FRUs (CRUs)
- Chapter 4. Removing a FRU or CRU
- Service tools
- General guidelines
- Removal procedure for IdeaPad Flex 5 14IAU7 and IdeaPad Flex 5 14ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD)
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the system board
- Remove the touchpad
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Removal procedure for IdeaPad Flex 5 16IAU7 and IdeaPad Flex 5 16ALC7
- Remove the lower case
- Remove the battery pack
- Remove the solid-state drive (SSD) module
- Remove the Wi-Fi card
- Remove the heat sink
- Remove the fan
- Remove the I/O board
- Remove the I/O board cable
- Remove the fingerprint board module
- Remove the speakers
- Remove the antenna
- Remove the touchpad cable
- Remove the touchpad
- Remove the system board
- Remove the LCD unit
- Remove the upper case
- Disassemble the LCD unit
- Appendix A. Label locations
- Trademarks
Remove the touch panel cable and sensor board
Make sure the following FRUs (CRUs) have been removed.
“Disassemble the LCD unit” on page 78
“Remove the hinge cover” on page 78
“Remove the LCD panel and EDP cable” on page 78 “Remove the camera” on page 82
Step 1. Peel off the tape.
Figure 91. Peel off the tape
Step 2. Detach the touch panel cable connector then remove the touch panel cable with sensor board.
Figure 92. Remove the touch panel cable with sensor board
Step 3. Disconnect the touch panel cable from the sensor board.
84
Hardware Maintenance Manual