Owner's Manual

2. Remove the computer cover. See “Computer cover” on page 15.
3. Remove the front bezel. See “Front bezel” on page 16.
4. Remove the screw from M.2 solid-state drive.
5. Slide the M.2 solid-state drive out.
6. Install the M.2 solid-state drive in.
7. Secure the M.2 solid-state drive with the screw.
8. Reinstall all removed parts.
9. Place the computer in an upright position. Then, reconnect the power cord and all disconnected cables
to the computer.
Note: If a locking device is available, use it to lock the computer.
Chapter 4. CRU replacement 23