User Manual

Table Of Contents

6. Reinstall all removed parts.

7. Place the computer in an upright position. Then, reconnect the power cord and all disconnected cables

to the computer.

Note: If a locking device is available, use it to lock the computer.

Heat sink and fan assembly

Prerequisite

Before you start, read Generic Safety and Compliance Notices, and print the following instructions.

The heat sink might be very hot. Before you open the computer cover, turn off the computer and wait several

minutes until the computer is cool.

Replacement procedure

1. Remove the power cord. See “Power cord” on page 14

2. Remove the right computer cover. See “Right computer cover” on page 17.

3. Remove the front bezel. See “Front bezel” on page 19.

4. Remove the fan power cable from the system board.

5. Remove the screws to remove the fan.

User Guide