Y330 User's Guide V1.0

Chapter 2. Using Your Computer
32
Note:
Make sure the Password on boot is set to Enabled if you need the
password protection at power on.
To set a User Password:
1 Turn on your computer. Press F2, while the initial screen is displayed.
The InsydeH20 Setup Utility screen opens.
2 Select Security, using the cursor directional keys.
3 Select Set User Password, and press the Enter key. The Set User
Password window opens.
4 Choose your user password, which can be from two to eight
alphanumeric characters in any combination. Type it in the Enter New
Password field.
5 Press the Enter key once to move to the Confirm New Password field.
Retype the password you just entered to verify it.
6 Commit your password to memory, and press the Enter key.
7 Press F10 to exit.
8 Select Yes in the Exit Saving Changes window.

Y330 User Guide V1.0 EN (08.06.18).book Page 32 Thursday, July 3, 2008 1:57 PM