Machine type: 10059/7723 10060/7724 10068/7752 10080/3099 H4 Series Hardware Replacement Guide Version 3.0 2011.
Hardware Replacement Guide ©. Copyright Lenovo 2011. All rights reserved. LIMITED AND RESTRICTED RIGHTS NOTICE: If data or software is delivered pursuant a General Services Administration “GSA” contract, use, reproduction, or disclosure is subject to restrictions set forth in Contract No. GS-35F-05925. ©. 2011.
Contents Overview....................................................................................... 1 Chapter 1 Locations.................................................................. 5 Locating components.....................................................................5 Locating connectors on the front of the computer..........................6 Locating connectors on the rear of the computer............................7 Identifying parts on the system board.....................................
Overview This guide is intended to be used by customers who are replacing Customer Replaceable Units (CRUs) as well as trained service personnel who are replacing Field Replaceable Units (FRUs). In this guide, CRUs and FRUs will be referred to as parts. Note: Trained service personnel should refer to the Hardware Maintenance Manual (HMM) for parts ordering information. This guide does not include procedures for all parts.
Additional information resources If you have Internet access, the most up-to-date information for your computer is available from the World Wide Web. You can find the following information: • CRU removal and installation information • Publications • Troubleshooting information • Parts information • Links to other useful sources of information To access this information, go to http://consumersupport.lenovo.com.
• Always handle parts and other computer components carefully. Handle adapters, memory modules, system boards, and microprocessors by the edges. Never touch any exposed circuitry. • Prevent others from touching the parts and other computer components. • Before you replace a new part, touch the antistatic package containing the part to a metal expansion slot cover or other unpainted metal surface on the computer for at least two seconds. This reduces static electricity in the package and your body.
4 Hardware Replacement Guide
Chapter Locations This chapter provides illustrations to help locate the various connectors, controls and components of the computer. To remove the computer cover, refer to “Removing the computer cover”. Locating components The following illustration will help you to locate the various components in your computer.
PCI express adapter card PCI express adapter connectors Power supply System fan Optical drive Hard disk drive Locating connectors on the front of the computer The following illustration shows the location of connectors on the front of the computer.
Note: This computer only can be placed in a vertical position. Locating connectors on the rear of the computer The following illustrations show the location of connectors on the rear of the computer. They show the placement of connectors for some but not all models. The location of the connectors on your computer may not be identical but should be similar to these. Please refer to the keys that follow the illustrations which identify the connectors.
Ethernet connector Microphone connector Audio line-out connector Audio line-in connector PCI Express X 16 graphics adapter connector (Some models are equipped with a graphic card) PCI Express X 1 adapter connector (Some models are equipped with a WIFI card or TV tuner card) Lenovo H405 Voltage selection switch (Selected models only) Power connector PS/2 keyboard connector PS/2 mouse connector HDMI connector (Selected models only) 8 Hardware Replacement Guide
On-board VGA connector (Selected models only) USB connectors (4) Ethernet connector Microphone connector Audio line-out connector Audio line-in connector PCI Express X 16 graphics adapter connector (Some models are equipped with a graphic card) PCI Express X 1 adapter connector (Some models are equipped with a WIFI card or TV tuner card) Lenovo H420 Voltage selection switch (Selected models only) Power connector PS/2 keyboard connector Hardware Replacement Guide 9
PS/2 mouse connector HDMI connector USB connectors (4) On-board VGA connector Ethernet connector Microphone connector Audio line-out connector Audio line-in connector Standalone graphic card (Selected models only) Expansion card slots (Access connectors for any installed PCI express cards) Lenovo H410 Voltage selection switch (Selected models only) Power connector 10 Hardware Replacement Guide
PS/2 keyboard connector PS/2 mouse connector On-board VGA connector (Selected models only) HDMI connector (Selected models only) USB connectors (4) Ethernet connector Microphone connector Audio line-out connector Audio line-in connector PCI Express X 16 graphics adapter connector (Some models are equipped with a graphics card) PCI Express X 1 adapter connector (Some models are equipped with a WIFI card or TV tuner card.
Identifying parts on the system board The system board (sometimes called the motherboard) is the main circuit board in your computer. It provides basic computer functions and supports a variety of devices that are factory-installed or that you can install later. The following illustrations show the locations of parts on the system board.
Serial (com2) connector Front USB connectors (2) Front audio connector PCI Express X 1 adapter connectors (3) PCI Express X 16 adapter connector System fan connector 12V power connector Lenovo H405 15 14 Microprocessor and heatsink Microprocessor fan connector Memory connectors (2) Thermal sensor header connector Power connector Hardware Replacement Guide 13
SATA IDE connectors (4) Front panel connector Front USB connectors (2) Clear CMOS Front audio connector PCI adapter connector PCI Express X 1 adapter connectors (2) PCI Express X 16 adapter connector System fan connector 12V power connector Lenovo H420 Microprocessor and heat sink Microprocessor fan connector 14 Hardware Replacement Guide
Memory connectors (2) Thermal sensor header connector Power connector SATA connectors (4) Front panel connector Front USB connectors (3) Serial(com2) connector Front audio connector PCI express X 1 adapter connectors (3) PCI express X 16 adapter connector System fan connector 12V power connector Lenovo H410 15 14 Microprocessor and heatsink Hardware Replacement Guide 15
Microprocessor fan connector Memory connectors (2) Thermal sensor header connector Power connector SATA IDE connectors (4) Front panel connector Clear CMOS Front USB connectors (2) Front audio connector PCI adapter connector PCI Express X 1 adapter connectors (2) PCI Express X 16 adapter connector System fan connector 12V power connector 16 Hardware Replacement Guide
Chapter Replacing hardware Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com Note: Use only parts provided by Lenovo.
5. Slide the computer cover to the rear of the chassis to remove it. Note: For this procedure, it helps to lay the computer on its side.
Removing and replacing the front bezel To remove and replace the front bezel: 1. Remove the computer cover. Refer to “Removing the computer cover”. Note: For this procedure, it helps to lay the computer on its side. 2. Remove the front bezel by releasing the three plastic tabs inside the chassis and pushing the bezel outward as shown. 3. To reinstall the bezel, align the plastic tabs on the bottom of the bezel with the corresponding holes in the chassis, then snap them into position at the bottom and top.
Replacing a memory module Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace a memory module: 1. Remove the computer cover. Refer to “Removing the computer cover”.
5. Refer to “Completing the installation”. Replacing the hard disk drive Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace the hard disk drive: 1. Remove the computer cover.
3. Remove the four screws that secure the hard disk drive to drive bay. 4. Remove the hard disk drive by pulling it straight out of the drive bay. 5. Slide the new hard disk drive into the drive bay. 6. Secure the new hard disk drive to the drive bay with the four screws. 7. Connect the power and data cables to the hard disk drive. Refer to “Identifying parts on the system board”. 8. Refer to “Completing the installation”.
5. Push the optical drive straight out of the front of the chassis. 6. Slide the new optical drive into the bay from the back until it snaps into position. 7. Secure the optical drive to the bay with the two screws. 8. Connect the data and power cables to the drive. 9. Install the front bezel. Refer to “Removing and replacing the front bezel”. 10. Refer to “Completing the installation”.
Replacing the heatsink assembly Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com To replace the heatsink assembly: 1. Remove the computer cover. Refer to “Removing the computer cover”. 2.
7. Use the thermal grease syringe to place five drops of grease on the top of the microprocessor. Each drop of grease should be 0.03ml (3 tick marks on the grease syringe). 8. Install the heatsink and fan assembly onto the heatsink retention bracket. 9. Reconnect the disconnected cables to the system board. 10. Refer to “Completing the installation”.
Replacing a PCI or AGP adapter Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at: http://consumersupport.lenovo.com. To replace an adapter: 1. Remove the computer cover. Refer to “Removing the computer cover”.
3. Install the new adapter into the same adapter connector. 4. Ensure the adapter is fully seated into the adapter connector. 5. Screw the latch into the chassis. 6. Refer to “Completing the installation”.
Replacing the keyboard and mouse Attention: Do not remove the computer cover or attempt any repair before reading the “Important safety information” in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace the keyboard: 1.
Completing the installation After replacing a part or parts, you must close the computer cover and reconnect all the cables, including telephone lines and power cords. Some parts will require confirming updated information in the Setup Utility program. Refer to “Starting the Setup Utility” in the Hardware Maintenance Manual. To complete the installation: 1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer.
4. Reconnect the external cables and power cords to the computer. Refer to “Locating connectors on the front of the computer” and “Locating connectors on the rear of the computer”. Note: In most areas of the world, Lenovo requires the return of the defective CRU. Information about this will come with the CRU or will come a few days after the CRU arrives.
Chapter Appendix Declaration Thank you for using Lenovo products. Carefully read all documents shipped with your computer before you install and use the product for the first time. Lenovo is not responsible for any loss except when caused by installation and operations performed by Lenovo professional service personnel. You are responsible if you fail to operate the product according to instructions and requirements in the manuals included with your computer, or operate the product inappropriately.
Trademarks Lenovo and the Lenovo logo, IdeaCentre and IdeaCentre logo are trademarks of Lenovo in the United States, other countries, or both. Microsoft, Windows, and Windows Vista are trademarks of the Microsoft group of companies. Intel Inside is a trademark of Intel Corporation in the U.S. and/or other countries.
