Operation Manual

Chapter 4: Configuring the Application
SecureMind Surveillance Manager
Page 44
 : Use the slide bar to set the time duration for alarm recording after
detecting an event. You set the time duration between 30 seconds to 180 seconds
5. In Select Cameras for alarm recordings, select the required camera from the list.
6. Click Camera Inputs to modify the camera inputs.
7. Follow Step 2a to Step 5.
8. In External Inputs, to modify the name:
9. Follow Step 2a to Step 5.
 Note: The external inputs can be triggered or reset by using the following HTTP requests:
Trigger: http://<nas-ip-address>/securemind/securemind-
cgi/camera_io.cgi?action=setExternalEvent&name=<external-input-name>
Reset: http://<nas-ip-address>/securemind/securemind-
cgi/camera_io.cgi?action=resetExternalEvent&name=<external-input-name>
10. Click Apply to apply the changes.
Configuring Outputs
The events in the SecureMind application can be used to trigger external device operations using the
Relay output port or camera output port.
 To configure the relay output, perform the following:
1. Click the Output Configuration panel.
Figure 37. Output Configuration