User manual

7. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 20 seconds after you connect the power
cord of the server to an electrical outlet before the power-control button
becomes active.
8. Start the Setup utility and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See
Chapter 6, “Configuring the server,” on page 103 for details.
Completing the installation
To complete the installation, complete the following steps:
1. If you removed the microprocessor 2 air baffle, replace the microprocessor 2 air
baffle (see “Installing the microprocessor 2 air baffle” on page 51 ).
2. If you removed the DIMM air baffle, install it now (see “Installing the DIMM air
baffle” on page 53).
3. If you removed either of the PCI riser-card assemblies, replace the riser-card
assemblies now (see “Installing a PCI riser-card assembly” on page 43).
4. If you removed the server cover, replace it:
a. Make sure that all internal cables are correctly routed.
b. Place the cover-release latch 1 in the open (up) position.
c. Insert the bottom tabs of the top cover into the matching slots in the server
chassis.
d. Press down on the cover-release latch to slide the cover forward and lock
the cover in place.
e. Slide the server into the rack.
5. Install the server in a rack. See the Rack Installation Instructions that come with
the server for complete rack installation and removal instructions.
6. To attach peripheral devices and connect the power cords, see “Connecting the
cables” on page 101.
100 ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide