Lenovo Server 3797 : User manual : Page 54

4. Press down on the left and right side latches and pull the server out of the rack

enclosure until both slide rails lock.

Note: You can reach the cables on the rear of the server when the server is in

the locked position.

The following illustration shows how to remove the cover.

5. Press the blue latch 1 on the end of the cover-release latch 4 and lift the

cover-release latch 2. Slide the cover forward 3 and lift the cover off the

server. Set the cover aside.

Attention: For proper cooling and airflow, replace the cover before you turn on

the server. Operating the server for extended periods of time (over 30 minutes) with

the cover removed might damage server components.

Internal cable routing and connectors

The following illustration shows the internal routing and connectors for the two SAS

signal cables (in server models with eight SAS drive bays).

Notes:

1. To connect the SAS signal cables, make sure that you first connect the signal

cable, and then the power cable and signal cable.

2. To disconnect the SAS signal cables, make sure that you first disconnect the

power cable, and then the signal cable and configuration cable.

38 ThinkServer RD220 Types 3729, 3779, 3797, and 3798: Installation and User Guide