Operation Manual

Attention: Do not touch the contact edge of the memory module. Otherwise the memory module might get
damaged.
To replace a memory module:
1. Disable the built-in battery. See “Disabling the built-in battery” on page 88.
2. Ensure that the computer is turned off and disconnected from ac power and all cables.
3. Close the computer display and turn the computer over.
4. Remove the bottom cover. See “Replacing the bottom cover” on page 88.
5. Open the latches on both sides of the memory slot at the same time
1 , and then remove the memory
module
2 .
6. Insert the new memory module into the memory slot at an angle of about 20 degrees 1 . Pivot the
memory module downward until it snaps into place
2 . Ensure that the memory module is firmly installed
in the memory slot and cannot be moved easily.
7. Reinstall the bottom cover.
90
P1/X1 Extreme User Guide