User manual
Table Of Contents
- About this documentation
- Chapter 1. Meet your computer
- Chapter 2. Get started with your computer
- Chapter 3. Explore your computer
- Chapter 4. Accessories
- Chapter 5. Secure your computer and information
- Chapter 6. Configure advanced settings
- Chapter 7. CRU replacement
- Chapter 8. Help and support
- Appendix A. Important safety information
- Appendix B. Accessibility and ergonomic information
- Appendix C. Supplemental information about the Linux operating system
- Appendix D. Compliance information
- Appendix E. Notices and trademarks
6. Remove a M.2 solid-state drive. Remove the screw that secures the M.2 solid-state drive 1 . Then,
remove the drive out of the drive slot
2 .
7. Install a new M.2 solid-state drive. Insert the new M.2 solid-state drive to the drive slot. Then, pivot the
drive downward and install the screw to secure the drive.
8. Reinstall the base cover assembly.
9. Turn over the computer. Connect the ac power adapter and all disconnected cables to the computer.
Replacement procedure for the short M.2 solid-state drive
1. Disable the built-in battery. See “Disable Fast Startup and the built-in battery” on page 45.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn over the computer.
4. Remove the base cover assembly. See “Base cover assembly” on page 50.
Chapter 7. CRU replacement 55