User's Manual

Message Solution
2102: Initialization
error on HDD1
(Ultrabay hard disk
drive)
The hard disk is not working. Have the hard disk serviced.
2110: Read error on
HDD0 (Main hard
disk drive)
The hard disk is not working. Have the hard disk serviced.
2112: Read error on
HDD1 (Ultrabay
hard disk drive)
The hard disk is not working. Have the hard disk serviced.
The power-on
password prompt
A power-on password or a supervisor password is set. Type
the password and press Enter to use the computer. If the
power-on password is not accepted, a supervisor password
might have been set. Type the supervisor password and press
Enter. If you still see the same error message, have the
computer serviced.
The hard disk
password prompt
A hard disk password is set. Type the password and press
Enter to use the computer.
If you still see the same error message, have the computer
serviced.
Hibernation error The system configuration changed between the time your
computer entered hibernation mode and the time it left this
mode, and your computer cannot resume normal operation.
v Restore the system configuration to what it was before your
computer entered hibernation mode.
v If the memory size has been changed, re-create the
hibernation file.
Operating system
not found.
Verify the following:
v The hard disk drive is correctly installed.
v A startable disc is in the drive.
If you still see the same error message, check the boot
sequence, using the BIOS Setup Utility.
EMM386 Not
Installed - Unable to
Set Page Frame Base
Address.
Edit C:\CONFIG.SYS and change a line from
device=C:\WINDOWS\EMM386.EXE RAM
to
device=C:\WINDOWS\EMM386.EXE NOEMS
and save this file.
Solving computer problems
16
ThinkPad
®
T61 Service and Troubleshooting Guide