Installation Guide

7
8. Route the three cables through the cutout on the rear of the FLEX module and replace the
cover. Starting from the rear of the module, engage the cover and slide it forward until it
clicks into place.
FLEX module and adapter card installation
Prepare the workstation for FLEX module installation by removing the side access cover.
Though not necessary, the rest of the installation will be easiest if the workstation is laid on its
side at this point.
1. Remove the plastic filler blank and the EMI shield from the 5.25” FLEX bay you intend to
use.
P520c
Remove the front bezel by releasing the three plastic tabs and rotating the bezel away
from the chassis.
Use the finger cutouts to pull the EMI shield out of the bay.