User Manual

the radio station in P01.
If the unit had not automatically searched for the station, it can only be saved in position
P01.
Press and hold button TUN+ for 2 seconds to search for next station.
Then stop searching, press the TIME SET/12_24H Button for two seconds,
P02 will show and flash on the display, TUN-/MEM- Button or TUN+/MEM+ Button to select
P01 or P02, Then press and hold the TUN-/MEM- Button or TUN+/MEM+ Button for two
seconds to store the radio station in P02.
(If P01 was selected, the previous P01 station was coved by new station).
Do the above steps one by one to search for all stations manually.
To increase FM radio reception:
To increase radio reception, uncoil the FM wire antenna. Straighten out the antenna and
attach it to a wall with tape at its highest point.
VOLUME:
When listening to the FM radio:
Press the VOL - button to decrease volume.
Press the VOL + button to increase volume.
DIMMER:
When the unit is in standby mode, press the SNOOZE/DIMMER button to adjust the
brightness of the display screen:
High-Medium-Low-Off; (Default: Medium)
USB PORT (on the rear of the unit):
For 5V/1A charging for smartphone.
Connect a charge lead (not included) to the USB port on the rear of the unit and the other
end to your smart phone to charge it.
WIRELESS CHARGING:
Put mobile phone with wireless charger function on the top of unit,
The LED indicator on the top panel of the unit will be illuminated when the phone is
connected to charge.
When the phone is fully charged, the indicator will no longer be illuminated.
BACK UP BATTERY:
Insert 2 x AAA batteries for clock back up in the event of a power outage.
The time display will be black when the unit is in battery backup mode.
When power is resumed, the time display will come on again showing the correct time.
If an alarm has been set, it will be saved in the event of a power outage.
If an alarm has been set, it will not awake at the set alarm time in the event of a power
outage.