Download

· The instructions shall state that the appliance is not intended to be operated by
means of an external timer or a separate remote-control system
·Children should be supervised to ensure that they do not play with the appliance.
HOW TO BOIL WATER:
Fill the tank with cold water. There is a maximum level marked on the inside of the
tank – do not fill above this mark. Make sure the environmental temperature indoors
is at about 10-38 degrees and the environmental humidity is less than 90%.
Replace the cover and switch the unit on. The heating lamp indicator should now light
up and the unit will begin to boil the water.
After about 35 minutes the water temperature will have reached 97 degrees and the
auto-thermostat switch the large heating element off and the small heating element on,
which automatically keeps the water at the correct temperature.
When about three cups of water are remaining in the tank, turn the unit off and unplug
it from the electric outlet.
THERMAL CUT-OUT:
The appliance is fitted with a thermal cut-out. If this is activated, the unit will turn
itself off, although the lamp with remain on. The unit must be unplugged before it
can be reset. To reset the appliance, wait until the unit has cooled down. The reset
button is located on the underside of the appliance.
This safety device may have been switched off during transport, if so reset the thermal
cut-off following the above instructions.
If resetting this thermal cut-out does not switch the unit back on, please contact the
manufacturer.
CLEANING THE APPLIANCE
This unit must be cleaned thoroughly after each use. This is in addition to a weekly
cleaning using vinegar to remove mineral deposits. If these deposits are not removed,
pitting of the metal can occur and may result in damage to the appliance.
CLEANING AFTER USE:
·Clean the tank, top cover and the body, etc. and dry them with a soft dry cloth. All
these part are made of stainless steel and can be cleaned with a scouring agent.
·If the appliance is to function properly, the cavity in the middle of the base must be