® MODEL 9190M PERSONAL AM/FM STEREO CASSETTE PLAYER Operating Instructions RECEIVES AM/FM BROADCASTS STEREO HEADPHONES INCLUDED BUILT-IN BELT CLIP REQUIRES 2 SIZE AA BATTERIES ( NOT INCLUDED) IB-9190M(MX)-WM-E-090902
LOCATION OF CONTROLS 2 1 10 3 9 4 8 5 6 7 1. FUNCTION SWITCH - Select TAPE, AM, or FM function. 2. TUNING CONTROL - Tune the stations. 3. STEREO HEADPHONE JACK - Plug headphones into this. 4. VOLUME CONTROL - Adjust volume. 5. FAST FORWARD BUTTON (FAST F.) - Advance the tape quickly. 6. PLAY BUTTON - Play the tape. 7. STOP BUTTON - Stop the tape. 8. CASSETTE DOOR - Insert the tape from here. 9. BELT CLIP (at the back of the set) 10.BATTERY DOOR - Slide to open (at the back of the set).
Congratulations! You now own a personal radio cassette player, which is able to offer personal listening with your headphones. BATTERY INSTALLATION Slide the BATTERY DOOR in the direction shown by the arrow to open the door and insert 2 AA batteries, taking care not to reverse the positive and negative polarities. Alkaline batteries are recommended and will normally provide more playing time. Do not mix old and new batteries.
TO INSERT THE TAPE 1. Open the cassette door by holding the door as shown and gently pulling it to you. 2. Insert the tape into the cassette holder ON THE DOOR. 3. Close the cassette door gently till it clicks shut. TAPE PLAYING DIRECTION FULL REEL ON THE RIGHT SIDE CAUTION: Do not pull the door too strongly or you may damage the door, treat this set with care and it will last a long time. TAPE PLAY 1. Check whether or not the tape is tight before it is inserted.
CLEANING TAPE HEAD If the sound drops out or excessive noise occurs, clean the magnetic head, capstan and pinch roller with a cotton swab moistened with alcohol. SPEAKER USE PINCH ROLLER CAPSTAN MAGNETIC HEAD COTTON SWAB To use the speakers as a desk-top cassette, simply plug the speakers plug into the Headphone Jack of the player. Adjust the Volume to the level you like. NOTE: These are not amplified speakers. This means the sound will not be very loud.
GENERAL SPECIFICATION Output power (Max) Power source Tape Section Speed deviation Frequency response Radio Section Frequency range: : More than 20 mw/ch : 2 AA Alkaline batteries : +3% -2% : Standard normal bias cassette tape 70Hz - 10kHz FM: 88 - 108 MHz AM: 530 - 1700 kHz LIMITED WARRANTY We warrant this product to be free from defects in material and workmanship under normal use for a period of 90 days after purchase and we will repair it free of charge or replace it at no charge, should it becom
