User Guide

IB-HT400-WM-E-110502

HT-400

AMPLIFIER

Test Tones

You can check whether your speakers are connected correctly by using

the TEST TONE button.

1 Press the POWER button on the front panel of the main unit to turn the main

power on, press SOURCE or MASTER VOLUME buttons on the main unit,

or any button on the REMOTE control to turn the set on. Make sure the

STANDBY indicator is lit in green.

2 Press the TEST TONE button on the REMOTE.

3 You will hear a test tone (actually some blank noise similar to a steady

ocean wave) from the FRONT LEFT (FL), CENTER (C), FRONT RIGHT

(FR), REAR LEFT (RL) and REAR RIGHT (RR) speakers in sequence. The

VOLUME indicators on the front panel will show the corresponding speaker

which is being tested.

4 After your test, you may play the theater system or adjust the individual

volume controls while playing any music or movie and then retest the

levels if you like. You may then adjust each speakers volume level by

pressing the VOLUME controls of the individual speakers, so that from your

center listening position, they all have approximately the same sound level.

To restore all speaker levels to their defaults, press the RESET button.

(FL) (C) (FR)

(RL)

(RR)

NOTE: The (FL), (C), (FR), (RL) & (RR) letters are not shown on the front

panel of your set.

NOTE: You can stop the test tone by pressing any button on the

REMOTE control, or press the SOURCE or MASTER

VOLUME buttons on the main unit.

NOTE: If the set is in STEREO mode (the red STEREO indicator is ON),

pressing the TEST TONE button will change the set from

STEREO to MULTI CHANNEL DECODING mode automatically,

and the blue MULTI CHANNEL DECODING indicator will light.

RESET BUTTON

Pressing this button on the remote

control will reset all 5 satellite

speakers and the subwoofer to

their default setting and will also

reset the preset graphic equalizer

to the normal position.

IB-HT400-WM-E-110502.p65 11/5/02, 3:28 PM22