User Manual

Lenze · Controller | Parameter setting & programming · Reference Manual · DMS 1.5 EN · 04/2014 · TD17 58
7 Programming with the »PLC Designer«
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7 Programming with the »PLC Designer«
This chapter provides you with general information on the programming of
the control function of the controller.
The »PLC Designer« is a Lenze Engineering tool for the creation of PLC
programs according to IEC 61131.
The following programming languages can be used:
• Instruction list (IL),
• Ladder diagram (LD),
• Function block diagram (FBD),
• Structured text (ST),
• Sequential function chart (SFC),
• Function block diagram (CFC).
The completely created and compiled PLC program can be transferred to the
controller by means of the »PLC Designer«.
The PLC program can then be executed on the controller by the runtime
software (Logic/Motion).
 Note!
Controller c300/p300:
In the »PLC Designer«, the configuration/parameter setting of field devices below the
Controllers c300/p300 is only possible "offline".