Owner manual

6

6.8 Oscillation damping 96
6.9 Load change damping 96
 2YHUORDGSURWHFWLRQV 
7.1 Overload protection of the frequency inverter (I⋅t monitoring) 97
7.2 Overload protection of the motor 97
7.2.1 PTC input 97
7.2.2 I²⋅t monitoring 98
 'LVSOD\IXQFWLRQV 
8.1 Code set 99
8.2 Language 99
8.3 Display of the actual values 100
8.4 Switch-on display 100
8.5 Identification 100
 &RGHWDEOH 
 6HULDOLQWHUIDFHV 
10.1 LECOM1 interface X6 109
10.2 LECOM2 interface (option) 110
10.3 LECOM codes 110
10.3.1 Controller address 110
10.3.2 Operating state 110
10.3.3 Controller state 110
10.3.4 Pole pair number 110
10.3.5 Baud rate (LECOM1) 111
10.3.6 History of reset faults 111
10.3.7 Code bank (LECOM1) 111
10.3.8 Enable automation interface (LECOM2) 111
10.3.9 High resolution data 112
10.4 Attribute table 113
6HUYLFH
 )DXOWLQGLFDWLRQ 
 :DUQLQJ 
 0RQLWRULQJ 
 &KHFNLQJWKHSRZHUVWDJH 
4.1 Checking the mains rectifier 120
4.2 Checking the power stage 120
4.3 Checking the voltage supply on the control board 8602MP 120
,QGH[ 