User Manual

12.3.5 Baud rate (LECOMI)
Under code Cl 25 you tan enter different baud rates.
Code
Cl25
Parameter
Meaning
4% 9600 baud
-l- 4800 baud
-2-
2400 baud
-3- 1200 baud
12.3.6 History of reset faults
Under Cl 61 to Cl 68 you tan read the last eight faults stored. The
last reset fault is displayed in Cl 61.
12.3.7 Code bank (LECOMI)
With version 1 .O of the LECOM A/B protocol, Codes up to C255 tan
be processed. To resch also higher numbers with this Version, the
accessible range tan be changed by code C249. Code C249 exists
in every range.
Parameter In C249 Access to code range
-O- cooo...c255
-l- C25O...C505
-2- c5oo...c755
-3-
c750...c1005
-4 C1000...1255
-5- C125O...C1505
-6- c15oo...c1755
-7-
C175O...C2000
Further information about serial communication with the Standard
interface LECOMl (LECOM-AIB), tan be obtained from the
technical description LECOM-A/B, which we will be pleased to send
you on request.
12.3.8 Enable automation interface (LECOM2)
If you want to integrate the controller into complex automation
Systems, you tan connect an interface, e.g. Interbus-S or Profibus
or an automation module. Install the module and activate it under
c370.
Code 1 Parameter ) Meaning
c370 4%
-l-
No communication via automation interface
(LECOM2)
Communication via automation inteface (LECOM2)
ena hkx-l
If the communication via C370 is enabled but an automation
module is not connected, the controller is inhibited.
142
lenze