Owner's manual
Table Of Contents
- KHB 13.0003-EN
- Document history
- Contents
- 1 Preface
- 2 Safety instructions
- 3 Technical data
- 4 Electrical installation
- 5 CANopen communication
- 6 Commissioning
- 7 Parameter setting
- 7.1 Loading and saving of parameter sets
- 7.2 Conversion factors ( factor group)
- 7.3 Power stage parameters
- 7.4 Motor adaptation
- 7.5 Speed controller
- 7.6 Position controller ( position control function)
- 7.7 Digital inputs and outputs
- 7.8 Device information
- 7.9 Manufacturer-specific information parameters
- 7.10 Manufacturer-specific driving records
- 8 Device control
- 9 Operating modes
- 10 Appendix
- 11 Index
Appendix
Index table
10
137
KHB 13.0003-EN 2.0
Characteristics
Possible settingsNameIndex
DescriptionSelectionLenze
2006
h
0 local_input_
function
0
-128 {1} 127
VAR INT8 RW —
Digital input can be
parameterised by the user.
Value Function Active
-128 ... -9 Reserved
-8 Start/stop Low
-7 Reserved
-6 Stopover Low
-5 Synchronisation Low
-4 Reserved
-3 Quick stop Low
-2 Power stage off Low
-1 Reference Low
0 No function
1 Reference High
2 Output stage off High
3 Quick stop High
4 Reserved
5 Synchronisation High
6 Stopover High
7 Reserved
8 Start/stop High
9 ... 127 Reserved
2007
h
0 absolute_
resolver_position
-1
{1 inc}
VAR INT16 RW —
Determining the absolute
resolver position within
one revolution.
2008
h
Maximum_control _
difference
0 number_of_
supported_entries
00
h
{1
h
} 02
h
VAR UINT8 RO —
Maximally supported
subindices.
02
h
Three subindices are
supported.
1 maximum_
positive_
control_difference
{1 rpm}
VAR UINT1
6
RW —
Set the setting to 0 to start
measurement.
2 maximum_
negative_
control_difference
{1 rpm}
VAR UINT1
6
RW —
Set the setting to 0 to start
measurement.