Owner's manual

CANopen communication
Parameter data transfer (SDO transfer)
Telegram structure
5

19
KHB 13.0003-EN 2.0
Command code
11 bits 4bits User data (up to 8 bytes)
1st byte 2nd byte 3rd byte 4th byte 5th byte 6th byte 7th byte 8th byte
Identifier
Data
length
Command
code
Index
low byte
Index
high byte
Subindex
Data 1 Data 2 Data 3 Data 4
Error code
The command code contains the services for writing and reading parameters and the
information on the length of the user data.
Structure of the command code:
Write command code
Bit 7
MSB
Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
LSB
Comment
CS 0 Length e s
Write command / write request 0 0 1 0 x x 1 1
CS: command
specifier
User data length
is coded in bits 2
and 3:
z 00=4bytes
z 01=3bytes
z 10=2bytes
z 11=1byte
Response to write command / write
response
0 1 1 0 x x 0 0
Read command code CS 0 Length e s
Read command / read request 0 1 0 0 x x 0 0
Response to read command / read
response
0 1 0 0 x x 1 1
Error command code CS 0 Length e s
Error response 1 0 0 0 0 0 0 0
The command code specifies whether a value is to be read or written. The command code
also determines the data length (1 byte, 2 bytes, 4 bytes).
Write command code
4-byte data
(5th ... 8th
byte)
2-byte data
(5th and 6th
byte)
1-byte data
(5th byte)
hex hex hex
Write command / write request
(Send parameters to the drive)
23 2B 2F
Response to write command / write response
(Response of the drive controller to the write request
(acknowledgement))
60 60 60
Read command code
Read command / read request
(Request to read a parameter from the drive controller)
40 40 40
Response to read command / read response
(Response to the read request with the actual value)
43 4B 4F
Error command code
Error response
(The drive controller signals a communication error)
80 80 80