Manual

Single-axis controllers
Control terminals
4

145
EDS94SPP101 EN 7.1
Terminal X3 Labelling Description
GA GND analog signals
AO1 Analog output 1
AO2 Analog output 2
A1+ Analog input 1 +
A1- Analog input 1 -
A1- Analog input 1 -
A1R Terminating resistor for ±20mA
A2+ Analog input 2 +
A2- Analog input 2 -
SSP94000X3

Shield connection: Fix the shield with EMC wire clamp.
Terminal data
Conductor cross-section Tightening torque
[mm
2
] [AWG] [Nm] [lb-in]
Flexible
0.2 ... 2.5
24 ... 12 Spring terminal
With wire end
ferrule
 Note!
If the control terminals are completely wired, we recommend to use a cable
cross-section of max. 0.75 mm
2
to save space. The mechanical cover can then
be attached.