Manual

Regenerative power supply modules
Mechanical installation
Important notes
7

285
EDS94SPP101-7.1
7.5 Mechanical installation
7.5.1 Important notes
 Note!
The devices must be installed in housings (e.g. control c abinets) to meet
applicable regulations.
 Stop!
Heavy device weight
The device is very heavy and must be lifted for the mounting.
Possible consequences:
ƒ Injury to persons, particularly backache when lifting and holding the device,
respectively
ƒ Injury to persons and damage to material assets due to the device falling
down
Protective measures:
ƒ The device must only be carried with a load bearing system such as an
indoor crane permitted for the device weight
ƒ Before the transport, the hoist, the load bearing system and lifting
accessories must be checked for sufficient payload and faultless status
ƒ Do not remove the hoist and the lifting accessories until the device lies safe
on a stable surface or is finally mounted.
ƒ The mounting location must always fulfill the operating conditions specified in the
Technical data. ( 263). If necessary, take additional measures.
ƒ The mounting plate of the control cabinet must be:
– electrically conductive
– free of lacquer
ƒ The mechanical connections must always be ensured.
ƒ The described EMC properties are provided if the following conditions are complied
with:
– The devices are mounted according to the arrangement concept described.
– The prepared cables are used and remain unchanged.