Manual

Accessories (overview)
Motor holding brake control modules
Motor holding brake control module E94AZHN0025
9

440
EDS94SPP101 EN 7.1
Elements of the motor brake control
Pos. Description
 Nameplate
X117 Control connection
X107 Connection of supply and brake
Standards
Conformity and approval
Conformity
CE
2006/95/EC Low -Voltage Directive
Approval
UR UL 508C Industrial Control Equipment Recognised
(file no. E132659) for USA
Protection of persons and equipment
Enclosure EN 60529
IP00
Protective measures Against short circuit
Mounting conditions
Mounting place
In the control cabinet
Mounting position Vertically
Mounting clearances
Above/below ≥ 25 mm
To the sides Side-by-side mounting without clearance
EMC
Noise emission EN 61800-3
Conducted, category C2.
Noise immunity EN 61800-3
Burst on mains cable: 2kV/5kHz
Burst on control cable: 2kV/5kHz
Surge on mains cable:
1kV(1.2μs/50 μs;
phase - phase)
2kV(1.2μs/50 μs; phase - PE)
Operating conditions
The operating conditions correspond to the operating conditions for the standard device
to which the DC-feeding point is connected.