Manual

Accessories (overview)
Motor holding brake control modules
Motor holding brake control module E94AZHY0025
9

451
EDS94SPP101 EN 7.1
Installation steps
1. Plug the motor brake control module onto the t erminals  of the standard device.
– Ensure that both clips  snap into the slots  of the standard device!
2. Check that the motor brake control module is securely connected.
Terminal data
Terminal X107 Labelling Description
Connection of t he motor holding brake:
BD1
BD2
+(Lenze:WH)
-(Lenze:BN)
E94AZHY0025: 205 V DC, max. 0.75 A
Ensure correct polarity!
SSP94A6107
L1
L2/N
Supply voltage of the motor holding brake
Terminal data
Conductor cross-section Tightening torque
[mm
2
] [AWG] [Nm] [lb-in]
Flexible
0.5 ... 2.5
20 ... 12 Spring terminal
With wire end
ferrule
Stripping length or contact length: 8 mm
Connection plan
L1
L2
L3
N
PE
F10
BD1BD1
L1 L3 PEL2 L1 L3 PEL2
BD2BD2
M
3~
M
3~
£ 2.5 mm²
E94APNExxx4 E94ASxExxx4E94AMxExxx4
E94AZHY0025E94AZHY0025
L1
L2/N L2/N
L1
"
"
"
"
X107X107
E94AZH016
F10
Observe the cable protection standards for fuse dimensioning!
 HF shield termination through large-surface PE connection