User guide

EDS84AYCER EN 2.0 - 11/2010 L 77
E84AYCER communication manual (PROFINET)
Error messages
Possible causes and remedies
PROFINET: Station name error [0x01bc6532]
PROFINET: IP address error [0x01bc6533]
PROFINET: Stack init error [0x01bc6534]
PROFINET: Internal error [0x01bc6650]
Response (Lenze setting in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble : Warning locked  Warning  Information
Cause Remedy
A station name that is not conform to PROFINET has
been defined.
Change the station name in accordance with the
PROFINET specification:
• 1 or several labels separated by ".".
• Max. length per label: 63 characters
• Max. total length: 240 characters
• Permissible characters: [a ... z], [0 ... 9], [.], [-]
• Labels must not begin or end with [-].
•Prohibited syntax:
–"n.n.n.n" (n = 0 ... 999)
–"port-xyz" (x,y,z=0...9)
–"port-xyz-abcde" (a,b,c,d,e,x,y,z=0...9)
Response (Lenze setting in bold) Setting: not possible
 None  System fault : Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
An invalid IP address has been assigned by the IO
controller via PROFINET or has been set in code C13000
.
• Make sure that the IO controller has assigned a valid
IP address via PROFINET.
• Set a valid IP address.
Setting the IP configuration
( 38)
Response (Lenze setting in bold) Setting: not possible
 None  System fault : Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The stack cannot be initialised with the parameters
selected by the user. This may be due to a station name
which does not comply with the PROFINET specification.
Check and, if necessary, adapt PROFINET parameters:
Setting the IP configuration
( 38)
Setting the station name
( 36)
Response (Lenze setting in bold)
 None  System fault : Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Send device with error description to Lenze.