User guide

5 Function blocks
5.8 L_CamSetContDataSDO - contactor data selection via codes/SDOs
172
Lenze · 9400 function library · Reference manual · DMS 6.7 EN · 08/2014 · TD05
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
5.8 L_CamSetContDataSDO - contactor data selection via codes/SDOs
This FB serves to select contactor data independent of the cam technology (CamDesigner/LC1 file)
directly via codes.
• The codes can be written, for instance, via parameter data objects (SDOs) by a master control.
• The FB supports "Teaching" of cams.
• The contactor data are transferred to the FB L_CamContactor
via the ContactorData output.
•The FB L_CamSetContDataPDO
serves to select the contactor data via inputs/PDOs.
Function library: LenzeCam FB is available as of library V01.02.xx.xx!
FB may only be used for firmware as of V3.0!
Runtime software licence:  Motion Control HighLevel  Motion Control TopLevel
 Note!
After changing the contactor data during operation:
Save the parameter set and the cam data with mains failure protection in the memory
module (e.g. using the device command C00002 = "11: Save start parameter").
&RQWDFWRU'DWD
E(UURU
/B&DP6HW&RQW'DWD6'2
GQ7HDFK&DP2Q
GZ7HDFK&DP,QGH[
$[LV'DWD
E7HDFK
GQ7HDFK&DP2II
&
&
3RVXQLW
& 6WDWH
6'2
& &&
& &&
& &&
& &&
& &&
& &&
& &&
& &&
6ZLWFKRQ 6ZLWFKRII
WLPHSRVLWLRQSRVLWLRQ
&DPW\SH
&
&DPQXPEHU
7HDFK