Instruction Manual

CNC programming
Data fields
P field
3
3.5
3.5.1
l
184
EDSTCXN EN 2.0
UnitSyncMeaningIndex
556 Current processing state of channel 0 for diagnosis
purposes
0: Idle
1: Run
2: Brake termination
3: Termination wait quit
4: Termination
5: Brake interrupt
6: Interrupt
7: Brake block jump
8: Block jump
9: Brake interrupt
10: Interrupt
11: Brake error
12: Error
13: Balancing run
x
557 Current increment, e.g. stitch length during sewing x mm *
558 Current interpreter state
0: No program active
1: Single function active
2: Program active
3: Interrupt program active
4: Block search active
x −−−
559 Bit coded state of modal functions
Bit0: 0=route operation (G30), 1=path operation (G31)
Bit1: 0=empty run (M15,M16,M21), 1=profile (M14)
Bit2: 0=event handler disabled (G132), 1=event handler
enabled (G133)
Bit3: 0=override enabled (M48), 1=override disabled
(M49)
Bit4: 1=G114 active
Bit5: 1=G231 active
x −−−
560 Current line number (not block number) in the NC
program
x −−−
561 Current setpoint speed, e.g. for a spindle. Corresponds
to the value programmed for address E in the DIN block
(G0−G3).
x −−−
562 Number of the M function, by which the last
subprogram call was triggered. For use in cycles, which
are called by M functions (MK_MFKT_UPR_TABELLE).
−−−
563 Last output H function number x −−−
564 Current number of preprocessed blocks in the block
search buffer
−−−
565 Geometry counter for block progress display x −−−
566 Progress display for current traversing block: 0=block
start, 1=block end
x −−−
567 Efficiency of geometry filter G200 in % x %
576 Number of the NC channel, for which the subsequent
data is valid.
x −−−
577 Current program number x −−−
578 Current block number x −−−
579 Current logical block number x −−−
583 Total of all executed profile pieces without empty runs
since the start of the program
x −−−
584 Covered path length in the current block x −−−
585 Current tool coordinate system Tn x −−−
586 Current tool coordinate system Sn x −−−
587 Current path speed x mm/GIT *