Instruction Manual

Interface PLC <˘> NC operating system

Definitions

Data block 1

5.1

5.1.2

262

EDSTCXN EN 2.0

0 Start of the NC program entered in the P field (512)

1 Start of the NC program entered in the P field (514)

2 Start of the NC program entered in the P field (516)

3 Start of the NC program entered in the P field (518)

4 Start of the NC program entered in the P field (520)

5 Start of the NC program entered in the P field (522)

6 Start of the NC program entered in the P field (524)

7 Start of the NC program entered in the P field (526)

15 Start of the automatic home position approach

0 No response

1 Start (normal procedure)

2 Start block search (P528−P532 configuration of the entry point)

11 Resumption of a program which was interrupted by an error at a defined point (G10)

12 Resumption of an interrupted program after normal operation has been resumed

(implicitly)

13 Resumption of a program which has been interrupted by an error without any previous

correction measures

14 Start after M0/M1

15 Start of the next block in individual operation

Effect in the PLC: Checking the start prerequisites for the respective start

mode and, if required, enable of the program start by setting the "Pro-

grammstart" ("Program start") signal (DW 009). Output of a corresponding

error message if the start is denied.

Values of the nibble with the

higher value

Values of the nibble with the

lower value