Users Manual Part 3

ManualsBrandsLEOMO ManualsCell PhonesSmartphone

CERTIFICATION INFORMATION

 FCC DECLARATION OF CONFORMANCE

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

Changes or modications not expressly approved by the party

responsible for compliance could void the user‘s authority to operate

the equipment.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment o and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit dierent from

that to which the receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

z RF Exposure Information (SAR)

This device has been tested and meets applicable limits for Radio

Frequency (RF) exposure. Specic Absorption Rate (SAR) refers to

the rate at which the body absorbs RF energy. SAR limits are 1.6

Watts per kilogram (over a volume containing a mass of 1 gram of

tissue) in countries that follow the United States FCC limit and 2.0

W/kg (averaged over 10 grams of tissue) in countries that follow the

Council of the European Union limit. Tests for SAR are conducted

using standard operating positions with the device transmitting at

its highest certied power level in all tested frequency bands. To

reduce exposure to RF energy, use a hands-free accessory or other

similar option to keep this device away from your head and body.

Carry this device at least 10 mm away from your body to ensure

exposure levels remain at or below the as-tested levels. Choose the

belt clips, holsters, or other similar body-worn accessories which

do not contain metallic components to support operation in this

manner. Cases with metal parts may change the RF performance

of the device, including its compliance with RF exposure guidelines,

in a manner that has not been tested or certied, and use such

accessories should be avoided.

The highest FCC SAR values for the device are as follows:

• 1.38 W/kg@1g (Head)

• 1.20 W/kg@1g (Body)

 INDUSTRY CANADA DECLARATION OF CONFORMANCE

This device complies with Industry Canada’s licence-exempt RSSs.

Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference

that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada

applicables aux appareils radio exempts de licence. L’exploitation

est autorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareil doit accepter tout brouillage

radioélectrique subi, même si le brouillage est susceptible d’en

compromettre le fonctionnement.”

The device could automatically discontinue transmission in case of

absence of information to transmit, or operational failure. Note that

this is not intended to prohibit transmission of control or signaling

information or the use of repetitive codes where required by the

technology.

- the device for operation in the band 5150–5250 MHz is only for

indoor use to reduce the potential for harmful interference to co-

channel mobile satellite systems;

L’appareil peut interrompre automatiquement la transmission en cas

d’absence d’informations à transmettre ou de panne opérationnelle.

Notez que ceci n’est pas destiné à interdire la transmission

d’informations de contrôle ou de signalisation ou l’utilisation de

codes répétitifs lorsque cela est requis par la technologie.

Le dispositif utilisé dans la bande 5150-5250 MHz est réservé à

une utilisation en intérieur an de réduire le risque de brouillage

préjudiciable aux systèmes mobiles par satellite dans le même canal;