Install Instructions

1
Bulletin GLV-103
Old Rev. LV-103
August, 2018
1360 Elmwood Avenue, Cranston, RI 02910 USA
Phone: [phone] Fax: [phone]
Email: [e-mail]
Web Site: http://www.leonardvalve.com
INSTALLATION ADJUSTMENT SERVICE
THERMOSTATIC
WATER MIXING VALVE
SERIES LV-985, LV-985-LF, LV-985-SW, LV-985-SW-LF
IMPORTANT! Provide valve serial number, (located on valve cover) when ordering parts!!
INSTALLATION
1. Valve should be installed at a location where it can
easily be cleaned, adjusted or repaired.
2. The inlets are clearly marked on the valve body. Union
angle strainer checkstops furnished must be installed on
both supply lines as shown above.
3. A shutoff valve must be installed on the outlet pipe. Type
LV valves do not have a built-in shutoff.
4. Use solder, for best results use 95/5 flux and solder paste.
Supply pipes should be flushed before the valve is
connected. Flush outlet pipe and valve as soon as it is
connected.
CAUTION
All thermostatic water-mixing valves have limitations. They will not provide the desired accuracy
outside of their flow capacity range. Consult the flow capacity chart on page 5.
Minimum flow must be no less than as shown.
REMEMBER! THIS IS A CONTROL SYSTEM WHICH MUST BE CLEANED
AND MAINTAINED ON A REGULAR BASIS (SEE MAINTENANCE GUIDE AND
RECORD MGR-1000).
125 PSI (8.6 BAR) MAXIMUM OPERATING PRESSURE
L
E
O
N
A
R
D
V A
L
V
E
C
O
.
W
A
R
M
E
R
LV-985, LV-985-LF LV-985-SW, LV-985-SW-LF
WARNING: This product can expose you to
chemicals including lead, which is known to the State
of California to cause cancer. For more information, go
to www.P65Warnings.Ca.gov
!