Submittal Sheet

Submittal Data Sheet S-1200-LF
March, 2020
1360 Elmwood Avenue, Cranston, RI 02910 USA
Phone: [phone] Fax: [phone]
Email: [e-mail]
Web Site: http://www.leonardvalve.com
Engineer's Approval Job # ________________
Arch/Eng. ____________
Contractor ____________
© 2020 Leonard Valve Company
Printed in USA
Thermostatic
MIXING
VALVES
ASSE
1017
SWEAT CONNECTIONS
ONLY
TM-26-___-LF
TM-26-LF ¾” inlets and outlet
 Thermostatic water mixing valve with 1 GPM minimum flow
 Dura-trol
®
solid bimetal thermostat directly linked to valve porting
to control the intake of hot and cold water and compensate for
supply temperature or pressure fluctuations. Dura-trol
®
is highly
responsive and cannot be damaged by extremes in temperature.
 ¾” Sweat inlets and outlet
 1 GPM (3.7 l/m) minimum flow capacity
 Integral combination checkstops
 Internal parts of lead free bronze, lead free brass, and stainless steel
 Integral wall support
 Color-coded dial, HOT-COLD with directional indicators
 Maximum operating pressure 125 PSI (860 KPA)
 Adjustable high temperature limit stop set for 120º F (49º C) *
 See Flow Capacity Chart, reverse side, to select correct size
 Locking temperature adjustment knob
 Rough bronze finish
OPTIONS:
__ SUFFIX BDT – Ball valve with dial thermometer (shown page 2)
__ SUFFIX IT – Inlet thermometers (ship loose)
__ SUFFIX TC – Test connection (ship loose)
__ SUFFIX LWS – Less Wall support
NOTE: CP option is NOT available
Valve is ASSE 1017 Certified
Valve is CSA Certified
Note: Leonard Valve Company reserves the right of
product, or design modifications without notice or
obligation.
ECO-MIX
™
*NOTE: A limit stop, set for 120F (49C), is simply a mechanical
setting to prevent excessive handle rotation. If incoming water is
hotter than 150F (65.5C), the temperature of the factory test, the
valve when turned to full HOT may deliver water in excess of 120F
and the limit stop MUST BE RESET BY THE INSTALLER
WARNING: This product can expose you to
chemicals including lead, which is known to the
State of California to cause cancer. For more
information, go to www.P65Warnings.Ca.gov
!
Valve assembly is certified to meet Low-Lead
requirements of wetted surface area containing less
than 0.25% lead by weight. All other fittings and
components, the sum total of which comprise the
wetted surface of this product contains less than one
quarter of one percent of lead by weight.