Operation Manual

8 WDS Mode: WDS is commonly used in areas requiring multiple APs, where
wiring is not possible or costly and for providing back-up paths between APs. The
number of ports on an AP available for the WDS is dependent on the AP model.
Disable – select if there is only one LAN and the range of wireless cover is enough.
Lazy Mode - select if you don’t known the AP MAC Address on other APs, but you
must select the Phy Mode and EncryptType which is the same as other APs.
Bridge Mode – select if you two different LAN in network, and want to link together.
Of course, you need to select the Phy Mode and EncryptType in the same mode as
Lazy Mode, and need the AP MAC Address too, there you can use fill AP MAC
Address. Repeater Mode – select if you want to extend the LAN range. Of course,
you need to select the Phy Mode and EncryptType in the same mode as Lazy
Mode, and need the AP MAC Address too, there you can use fill AP MAC Address.
9 Operating Mode: This is the default setting Mixed Mode or setting Green Field;
10 Channel Bandwidth: Select the Channel Width: 20/40 - This is the default
setting. Select if you are using both 802.11n and non-802.11n wireless devices. 20 -
Select if you are not using any 802.11n wireless clients.
11 Guard Interval: Auto – check if reduce the guard interval time therefore
increasing the data capacity. However, it’s less reliable and may create higher data
loss. Reverse if check the long.
12 MCS: This is the default setting Auto Mode
13 Reverse Direction Grant(RDG): Enable - facilitate increased communication
channel bandwidth efficiency in association with scheduled time periods that allocate
channel access to particular stations. According to various aspects, systems and
methods are described that facilitate providing and/or utilizing reverse direction
grants in connection with scheduled channel access. It can mitigate an amount of
unused channel access time after a station completes data transmission prior to an
end of the allocated period. Disable – select if you don’t need this function.
14 Extension Channel: If the Frequency(Channel) select is not autoselect , the
Extension Channel is enable. You can select the Extension Channel you want to. It
can help speed recovery.
15 Aggregation MSDU(A-MSDU):
16 Auto Block ACK: Enable – select if you want to block ACK automatically. Or else
you can select Disable.
17 Decline BA Request: Enable – select if you want to Decline BA Request. Or else
you can select Disable.
4.2.2 Advance
You can set advanced wireless LAN parameters of this router. We recommend not
changing these parameters unless you know what changes will be there on this
router.
14