Operation Manual

1 BG Protection Mode: Select either Auto On or Off. Default is Auto

2 Basic Data Rates: Select the data rate. Default is 1-2-5.5-11-22-54Mbps

3 Beacon Interval: Beacons are packets sent by an Access Point to synchronize a

wireless network. Specify a value. 100 is the default setting and is recommended.

4 Data Beacon Rate (DTIM): (Delivery Traffic Indication Message) 1 is the default

setting. A DTIM is a countdown informing clients of the next page for listening to

broadcast and multicast messages.

5 Fragment Threshold: The fragmentation threshold, which is specified in bytes,

determines whether packets will be fragmented. Packets exceeding the 2346 byte

setting will be fragmented before transmission. 2346 is the default setting.

6 RTS Threshold: This value should remain at its default setting of 2432. If

inconsistent data flow is a problem, only a minor modification should be made.

7 TX Power (SSID): Set the transmit power of the antennas.

8 Short Preamble: Check this box to reduce the guard interval packet therefore

increasing the data capacity. However, it’s less reliable and may create higher data

loss.

9 Short Slot: Check this box to reduce the guard interval time therefore increasing

the data capacity. However, it’s less reliable and may create higher data loss.

10 Tx Burst: Click either Enable or Disable. Default is Enable.

11 Pkt_Aggregate: if Click Enable, the packets will be Aggregated before they sent.

Click either Enable or Disable. Default is Enable.