Operation Manual

Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE
connection. Your ISP will provide you with a user name and password. This option is
typically used for DSL services. Make sure to remove your PPPoE software from
your computer. The software is no longer needed and will not work through a router.
User Name: Enter your PPPoE user name.
Password: Enter your PPPoE password and then retype the password in the next
box.
MTU: Maximum Transmission Unit - you may need to change the MTU for optimal
performance with your specific ISP. 1492 is the default MTU.
MRU: Maximum Receive Unit - you may need to change the MRU for optimal
performance with your specific ISP. 1492 is the default MTU.
Choose PPTP (Point-to-Point-Tunneling Protocol ) if your ISP uses a PPTP
connection. Your ISP will provide you with a user name and password. This option is
typically used for DSL services.
PPTP Server IP Address: Enter the Server IP provided by your ISP (optional).. User
Name: Enter your PPTP user name.
Password: Enter your PPTP password and then retype the password in the next
box.
MTU:Maximum Transmission Unit - you may need to change the MTU for optimal
performance with your specific ISP. 1492 is the default MTU.
Address Mode: Select Static if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic. IP Address:
Enter the IP address (Static PPTP only).
Subnet Mask: Enter the Primary and Secondary DNS Server Addresses (Static
PPTP only).
Default Gateway: Enter the Gateway IP Address provided by your ISP.
19