Operation Manual

network.
2 L2TP passthrough: Enable – select if you want to let the L2TP packet pass
through the Wireless Router from WAN port.
3 IPSec passthrough: Enable – select if you want to let the IPSEC packet pass
through the Wireless Router from WAN port.
4 PPTP passthrough: Enable – select if you want to let the PPTP packet pass
through the Wireless Router from WAN port.
LAN Setting
4.4.1 LAN Interface
1 IP Address: the IP of LAN.
2 Subnet Mask: the subnet mask of LAN.
3 DHCP Type: Enable – select if you want to use the Wireless Router as a DHCP
server. And then Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you statically (manually) assign IP addresses to your computers or devices,
make sure the IP addresses are outside of this range or you may have an IP conflict.
4 802.1d Spanning Tree: The 802.1D Spanning Tree was designed at a time when
the recovery of connectivity after an outage within a minute or so was considered
adequate performance. Enable – select if you want this function.
5 LLTD: allows Wireless Router to query the other devices on the network so it can
determine how the network is organized. Enable – select if you want this function.
22