Operation Manual

1 Virtual Server Settings: Check Enabled to activate entry.
2 IP Address: enter the IP Address of the computer on your local network that you
want to allow the incoming service to.
3 Port Range: enter the port range of the computer on your local network that you
want to allow the incoming service to.
4 Protocol: either TCP, UDP, or both. If you are not sure, select both.
5 Comment: Enter a name for your virtual server entry.
In the below of the page, you will see the current virtual servers in system you set.
You can delete some rules if you want on clicking Delete selected button when you
have selected.
4.6.3 Remote Control
Remote Control allows the device to be configured through the WAN (Wide Area
Network) port from the Internet using a web browser. A user name and password is
still required to access the browser-based management interface.
27