User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
28
RoutingTableInfo 0x20"
Application part of the list of known modules. For each index 3 requested destination of their associated
relay and level will be sent. The possible index values are from 0 to size max / 3, round up if max size / 3
does not give a whole."
TableLvl1 0x21"
Application part of the list of modules that are present in the table level 1. See the documentation on the
module concerned for details."
DebugInfos 0x22"
Information on the module. See the documentation on the module concerned for details."
Settings 0x23"
Request module parameters. See the documentation on the module concerned for details."
Rssi 0x24"
Returns signal strength. See the documentation on the module concerned for details."
MasterID 0x25"
Request the master ID."
Type of change
value
Description
Settings
0x23
module parameters Modifications
MasterID
0x25
Changing the master ID
ForceRelay
0x26
Changing IDforced relay
Password
0x26
Changing the password
ResetMcu
0x28
RestartModule
CloseDevice
0x29
Module Closing