User's Guide
Table Of Contents
- Document related firmware and hardware
- Form factor
- General Specifications
- Interfaces
- Specifications
- Regulatory conformity summary
- Technical Drawing
- GPIOs
- 16 pins connector
- 8 pins connector
- Power supply design
- Board layout
- Antenna performance
- Introduction
- Generic message structure
- Communication protocol
- Encryption (6 bits)
- Message Type (1 bit)
- Simplified Mode
- Message types
- Payload: Simplified Message type
- Message Type advanced
- Encryption Types
- Payload
- Payload [0] PayloadType <4: 0>
- payload [0] PayloadType <7: 5>
- TypeID
- Refresh
- DataWithoutAck
- DataWithAck
- FileTransfer
- Event
- Return
- Get
- Set
- Payload [1]: sub-type <7: 0>
- AckData 0x03
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- NackInfos 0x2B
- DecryptionError 0x2C
- WrongParameter 0x2D
- Payload [1]: subType <7: 0>
- TypeID 0x00
- Refresh 0x01
- RoutingTableInfo 0x20
- TableLvl1 0x21
- DebugInfos 0x22
- Settings 0x23
- Rssi 0x24
- MasterID 0x25
- 0x23Settings
- MasterID 0x25
- ForceRelay 0x26
- Password 0x26
- ResetMcu 0x28
- CloseDevice 0x29
- United States (FCC)
- OEM labeling requirements
- FCC notices
- FCC-approved antennas
- RF exposure
- CANADA - ISED (Innovation, Science and Economic Development Canada)
- Labeling requirements
- Detachable antenna
- EUROPE (CE)
- Maximum power and frequency specifications
- OEM labeling requirements
- Declarations of conformity
- Antennas
29
0x23Settings"
Changing the module parameters. See the documentation on the module concerned for details"
MasterID 0x25"
Changing the master ID. Put into the desired payload ID."
ForceRelay 0x26"
Changing the ID of forced relay. Put into the desired payload ID."
Password 0x26"
Changing the password. Put in the payload the desired password."
ResetMcu 0x28"
Reset the microcontroller."
CloseDevice 0x29"
Close the module. Provide the unit of time (see Table 11) on a byte tracking time of 2 bytes (MSB
followed by the LSB). Example: 4096 minutes = 0x02 0x10 0x00"
Table 11"
$$$$$$$"
$$$$$$"
Time unit
value
Milliseconds
0x00
Seconds
0x01
minutes
0x02
Hours
0x03