Owner's manual

AEROFLOW SUPPLEMENT

ANSI 4500 Aeroflow

TABLE OF CONTENTS

INSTALLATION & OPERATION

...................................................................2

MAINTENANCE

.....................................................................................................................2

VALVE

ASSEMBLY................................................................................................................................2

INSPECTION AND CLEANING

........................................................................2

ILLUSTRATION INDEX

IGURE

–

4500

EROFLOW WITH

PECIAL

HERMAL

ROWTH

RIM

..........................................................3

12501 Telecom Drive, Tampa Florida 33637

Installation, Operating and

Maintenance Instructions

Supplement

10/2.5.1.F

Rev. 2

PAGE 1
2501 Telecom Drive, Tampa Florida 33637 Installation, Operating and Maintenance Instructions Supplement 10/2.5.1.F Rev. 2 AEROFLOW SUPPLEMENT ANSI 4500 Aeroflow TABLE OF CONTENTS INSTALLATION & OPERATION ...................................................................2 MAINTENANCE.....................................................................................................................2 VALVE ASSEMBLY .........................................................................................
PAGE 2
the torque in three steps according to the following table: INSTALLATION & OPERATION 5. Refer to standard IOM 10/2.5.1for installation & operation. CAUTION! All warnings from standard valve IOM must be followed VALVE ASSEMBLY 1. Carefully position a new seat ring gasket (511) in the body (303) recess. Install seat ring (510) with seating surface upward. 2. Install load ring (504) on top of seat ring (510). 3.
PAGE 3
Figure 1 – 4500 Aeroflow with Special Thermal Growth Trim It is solely responsibility of system designer and user to select products and materials suitable for their specific application requirements and to ensure proper installation, operation and maintenance of these products. Assistance shall be afforded with selection of materials based on technical information supplied to Leslie Controls Inc.; however, system designer and user retain final responsibility.